How to configure a UTT SOHO router as an Access Point

Introduction

This document describes how to configure a UTT SOHO router as an Access Point on Network via Ethernet cable.

Prerequisites

Requirements
You have a router and only want UTT SOHO router as an access point for wireless users connect.
 
Components Used
UTT SOHO router AC650W;
Firmware Version: nvAC650Wv1.8.0-150319;

Background Information

Configure

Network Diagram
 
Configuration
  1. Power on your AC650W, connect your PC to AC650W LAN Port via an Ethernet cable, as shown in Figure 1-1:
Figure 1-1
 
  1. Check your another router's LAN Gateway IP address (you can check via the label on the router or contact the support)
If it isn't 192.168.1.1, just enter AC650W's Web Interface and skip to step5.
If it's the 192.168.1.1, you should change AC650W's LAN IP address as 192.168.1.2    (Any ip is ok, but should not be conflict with your another router, here we just use 192.168.1.2 as an example.). Configure as follows:
Type "http://192.168.1.1" on the address bar to enter AC650W's Web interface, as shown in Figure 1-2:
Figure 1-2
 
Go to "Application > LAN" page, as shown in Figure 1-3:
Figure 1-3
 
Click LAN icon, change 192.168.1.1 to 192.168.1.2, then click Save as shown in Figure 1-4:
Figure 1-4
 
  1. Disable your Local Area Connection on your PC, then enable Local Area Connection again, as shown in Figure1-5:
Figure 1-5
 
 
  1. Type "http://192.168.1.2" on address bar to enter AC650W's Web Interface again, as shown in Figure 1-6:
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Figure 1-6
 
  1. Go to "Application > DHCP" page, click DHCP icon, then disable DHCP Server, next click Save, as shown in Figure 1-7 and Figure 1-8:
Figure 1-7
 
Figure 1-8
 
  1. Connect your AC650W LAN Port to your router's LAN Port via another Ethernet cable, as shown in Figure 1-9:
Figure 1-9
 
Then disable your Local Area Connection on your PC, and enable Local Area Connection again, after your PC obtain an IP address from your router's DHCP Server, you can access the Internet.
 

Troubleshoot

1. Avoid DHCP conflict, there can't exist multiple DHCP Servers in the same broadcast domain at the same time, and the device which works as an access point should disable DHCP Server.

2. You cannot use the same LAN Gateway IP address in the same broadcast domain , it's better to change the LAN Gateway IP of the device works as an access point.